Lcd Status Monitor Message List - Oki OKIPAGE 10e Service Manual

6.5.1 LCD Status Monitor Message List

The status and problems which may be displayed by messages on the LCD are listed in Table 6-1.
Category Status Message
Normal status Warming Up
Online (Ready)
Power Save Mode
Toner Low
Toner Sensor
Change Drum
Manual Paper In
Printing in Progress
Ejection in Progress
Manual Request
Executive
Letter
Legal 14
Legal 13
A6
A5
A4
B5
Monarch
COM-10
DL
C5
COM-9
Paper size error Paper Size Error
Paper jam Paper Input Jam
Paper Feed Jam
Service Guide OKIPAGE 10e
Chapter 6 Troubleshooting
Code Display Content
10003 Warming-up status
10001 Online (ready) status Normal operation
10094 Power save status
10006 The toner amount of
the toner cartridge is
small
10093 The I/D unit is not
installed or the toner
sensor is faulty.
40093 Life of I/D drum
The paper is in the
manual feed mode
10098 Printing in Progress
X=0, Non Warning
X=1, Toner Low
X=2,3 Change Drum
10099 Ejection in Progress
X=0, Non Warning
X=1, Toner Low
X=2,3 Change Drum
Request the paper to
be set in the manual
feed mode.
The paper sizes are
as follows:
Executive, Letter,
Legal 14, Legal 13,
A4, A5, A6, B5,
Monarch, DL, C5,
COM-10, COM-9
Paper of improper
size was fed.
2.52" (64 mm) L
15.77" (400.56 mm)
40077 A paper jam occurred
when sheets of paper
were being supplied.
40078 A paper jam occurred
during paper feeding.
Remedy
Normal operation
Normal operation
Normal operation
Install the I/D Unit or replace the
toner sensor.
Change the I/D Unit and reset
Drum counter see Section 4.1.1 (1).
Replace the I/D unit. (Note: be sure
to reset the drum counter after
replacing the I/D Unit).
Normal operation
Normal operation
Set the requested paper in the
manual feed mode.
Check the paper. Also check
whether more than one sheet of
paper was fed simultaneously. To
release the error display, open the
cover, then close it. If this error
occurs frequently, see Section
6.5.2-3.
Check the paper. To release the
error display, close the cover, then
close it. If this error occurs
frequently, see Section 6.5.2.2-1.
Open the cover, then remove the
jammed paper. To release the error
display, close the cover. If this error
occurs frequently, see Section
6.5.2.2-2.
Page: 70