Status Monitor Message List - Oki OKIPAGE 8z Service Manual

6.5.1 Status Monitor Message List

Table 6-1 lists the statuses and troubles to be displayed on the status monitor in the message format.
Table 6-1
Category
Normal status
Normal status
Normal status
Normal status
Normal status
Normal status
Normal status
Normal status
Normal status
Normal status
Paper size error
Service Manual for OKIPAGE 8z
Chapter 6 Troubleshooting Procedures
Status Message Status
Code
Warming Up 18 00
Online (Ready) 00 10
Power Save Mode 00 20
Toner Low 10 00
Toner Sensor 10 01
Change Drum 10 02
Manual Paper In 12 20
Printing In 14 20
Progress
Ejection in 14 30
Progress
Manual Request
Executive 16 01
Letter 16 02
Legal 14 16 03
Legal 13 16 04
A6 16 18
A5 16 19
A4 16 1A
B5 16 21
Monarch 16 50
COM-10 16 51
DL 16 5A
C5 16 5B
COM-9 16 7F
Paper Size Error 30 00
Explanation
Warming-up status.
Online (ready) status.
Power save status.
The toner amount of the
toner cartridge is small.
The image drum is not
installed or the toner
sensor is faulty.
Image drum is nearing
end of life.
The paper is in the
manual feed mode.
Printing in progress.
Ejection in progress.
Request the paper to
be set in the manual
feed mode.
The paper sizes are as
follows: Executive,
Letter, Legal 14, Legal
13, A4, A5, A6, B5,
Monarch, DL, C5,
COM-10, COM-9.
Paper of improper size
was fed. 2.52" (64 mm)
L 15.77" (400.56 mm)
Page: 59
Remedy
Normal operation.
Normal operation.
Normal operation.
Normal
operation/replace
the toner cartridge.
Install the image
drum or replace
the toner sensor.
Replace the image
Note:
drum. Be
sure to reset the
drum counter after
replacing the
image drum).
Normal operation.
Normal operation.
Normal operation.
Set the requested
paper in the
manual feed
mode.
Check the paper.
Also check
whether more than
one sheet of paper
were fed