Main Control M5G-Pcb - Oki OKIPAGE 10e Service Manual

Page: 46
Service Guide OKIPAGE 10e
Chapter 3 Disassembly

3.3.21 Main Control M5G-PCB

(1) Remove the upper cover (see 3.3.1).
(2) Remove the operator panel assy (see 3.3.4).
(3) Remove the face up stacker assy (see 3.3.8).
(4) Remove the lower base unit (see 3.3.5).
(5) Remove the connector (2NDTRAY) (6).
(6) Remove the screws (1).
(7) Move the M5G-PCB Main Control Board (2) in the direction of arrow to disconnect it from the power supply/sensor
board (3).
(8) Remove the connector FAN, and disconnect the fan motor (4).
(9) Remove the M5G-PCB Main Control Board (2), together with the PCB guide plate (remove the fan motor (4) at the
same time).
(10) Remove three screws (8) and remove the PCB guide plate (7) from the M5G-PCB Main Control Board (2).
Note: When reinstalling the M5G-PCB (2) onto the guide plate (7), be careful not to bend the base plate (it is desirable
to place a block underneath it to prevent bending).