Menu Operations And Menu List; Menu Operations - Roland V-40HD Owner's Manual

Menu Operations and Menu List

Menu Operations

To make various settings for the V-40HD, use the menu screens displayed on the preview monitor. Menu operations are described below.
* For information on the menu items, refer to the following pages.
1. Display the menu screen.
Go to the SETUP section and press the [MENU] button to display the menu screen. Displayed initially is the first level.
fig.open.menu.eps
2. Select the target menu.
Use the up and down [CURSOR] buttons to select the target menu item at the first level.
fig.select-menu.eps
3. Select the target item.
Use the up and down [CURSOR] buttons to select the target item.
* If the items span two or more pages, a triangle symbol is displayed at the top of the screen. When this symbol is displayed, you can change the
page shown pressing the the left or right [CURSOR] buttons.
fig.select-item.eps
4. Proceed to the setup screen.
When [ENTER] is displayed at the top of the screen, you can proceed to a detailed setup screen for the item by pressing the [ENTER]
button.
fig.enter-setup-screen.eps
5. Change the setting value.
If the displayed setting value is highlighted, you can change the value by turning the [VALUE] dial.
fig.change-value.eps
* You can change a setting value up or down by 10 units at a time by holding down the [ENTER] button and turning the [VALUE] dial.
* You can also return a setting value to its factory default by holding down the [ENTER] button and pressing the [EXIT] button.
* Hold down [ENTER] button and [EXIT] button for 3 seconds or longer to return the setting values of all the displayed items to factory default
values. This returns the values of displayed items only. The values of the not-displayed items do not return.
6. Exit the menu.
You can go back one level by pressing the [EXIT] button. When you are finished making the settings, press the [EXIT] button several
times to quit the menu.
The setting value is not stored in internal memory unless it is saved to a [MEMORY] button. Refer to "Saving/Recalling Settings" (p. 40) and save
the settings before turning off the power.
Input
Set input parameters like source assignments.
Output
Set output parameters like output formats.
Transition
Set parameters of transition e ects.
PinP
Set parameters of Picture in Picture.
DSK
Set parameters of Down Stream Keying composition.
Audio
Set parameters of Audio.
System
Set system con guration of the V-40HD.
45