Switching The Video Using The Video Fader - Roland V-40HD Owner's Manual

Basic Operations
Switching the Video Directly
It is also possible to directly switch the video pressing the buttons in [A-BUS/PGM] section. However, a short black image is inserted
between 2 video images on the conditions below.
• When a direct switching operation is carried out while a logo/text is composited using the DSK function (p. 35).
• [DSK] is selected as the dislay mode of preview monitor and [PST] is selected as the output source for OUTPUT 1/2.
• [DSK] is selected as the output source for OUTPUT 1/2.

Switching the Video Using the Video Fader

When you use the [AUTO] button, the transition effect is applied for the time set using the [TRANSITION] dial. When you use the
video fader to perform a transition, you can control the length of the transition time manually.
1. Move the video fader all the way.
Before you carry out a transition operation, move the video fader all the way toward either the front or the back.
fig.fader-max.eps
2. Select a transition effect.
Use the [WIPE PATTERN] buttons to select the transition effect you want to apply.
* If you select [CUT], the transition occurs when the video fader is at its center position.
3. Select the channel you want to output next.
Use the input selectors in the [B-BUS/PST] section to select the channel of the video you want to output next (standby).
4. Switch the output video.
Move the video fader in the opposite direction of step 1. Moving it all the way makes the final output switch to the video on the
channel selected in step 3.
fig.move-fader.eps
30
or