Part Names And Functions; Top Panel - Roland V-40HD Owner's Manual

Part Names and Functions

Top Panel

fig.top-panel.eps
7
8
9
1. MEMORY Buttons
Use these to save the current settings to the internal memory (p. 40).
2. PVW (Preview) Selectors
These select the picture to output from the [PVW OUT] connector on the rear panel.
3. OUTPUT Selectors
Use the [FORMAT] button to switch the output format for OUTPUT 1 and 2.
* The format of PVW OUT cannot be changed.
4. AUDIO Indicators
These display the audio output level.
5. HDCP Indicator
This operates as described below, depending on the setting for HDCP signals (p. 26).
Lighted It lights up when an HDCP-compatible device is connected as the output device.
Flashing It flashes when no output device is connected or when the connected device is not compatible with HDCP.
Unlighted It goes dark when the V-40HD's HDCP-signal input/output mode is off.
6. OUTPUT FADE Button
This applies fade to final output. The button flashes while the fade is in progress. The button lights up continuously when a fade-
out has been completed. The button goes dark when a fade-in has been completed (p. 33).
* By default, the fade time is set at 0.5 seconds, and the fade goes to black. Use the menus (p. 50) to change the fade time and fade color.
14
1
10 11
2 3
12 13
4 5 6
14
15