Warning Messages - Sony SRW-5800 Operation Manual

Item number Display
10 DEW DETECTED
11 TAPE TOP/END SENSOR
12 TAPE TOP SENSOR TROUBLE
13 TAPE END SENSOR TROUBLE
14 FAN MOTOR TROUBLE
20 CASSETTE COMPARTMENT
MOTOR LOCK
21 REEL SHIFT MOTOR LOCK
22 REEL POSITION SENSOR
TROUBLE
23 THREADING RING POSITION
ERROR
24 DT HARD ERROR
26 POWER SUPPLY UNIT TROUBLE
93 DR INTERFACE ERROR
97 NVRAM CHECK SUM ERROR
FF SV UNDEFINED ERROR
A0 SYS UNDEFINED ERROR
A2 SYS1 - SYS2 DP-RAM ERROR
A5 SYS - FC DP-RAM ERROR
A8 SYS NV-RAM CHECK SUM ERROR
B3 XXX PLDX INITIAL ERROR
B8 SYS1 - SYS2 INTERFACE ERROR
B9 SYS - SV INTERFACE ERROR
BA SYS - EQ INTERFACE ERROR
BB SYS - FC INTERFACE ERROR
BC SYS - 50PIN INTERFACE ERROR

Warning Messages

When one of the problems described below is detected, a
warning mark is displayed in the upper left corner of the
display. Operation can continue even when the mark is
flashing.
If you press the SFT button (see page 19) and the DIAG
button (see page 17) when the mark is flashing, an
information display appears, showing a warning message.
150
Error Messages/Warning Messages/Condition Messages
Meaning
Condensation was detected.
The tape beginning and tape end were detected at the same time.
A tape beginning sensor fault was detected.
A tape end sensor fault was detected.
A cooling fan motor operation fault was detected.
A fault was detected in a cassette compartment raising or lowering
operation.
A fault was detected movement of the reel table to adjust for
cassette size.
The reel table was detected in the L cassette position and S
cassette position at the same time.
The threading end and unthreading end were detected at the same
time.
A fault was detected in DT mechanism.
A fault was detected in the power supply unit.
A communications error between the SV CPU (board SS-102) and
drum CPU (board DR-508) was detected.
An operation fault was detected in the servo system NV-RAM
(board DR-508).
Undefined SV error was detected.
Undefined SY error was detected.
A DPRAM (board SS-102) operation fault between SYS1 and
SYS2 was detected.
A DPRAM (board FC-91 or FC-111) operation fault between SYS1
and FC was detected.
A SYS NVRAM (board SS-102) operation fault was detected.
An initialization error in the PLD was detected.
Note
The description of "XXX" at the beginning of the message and of
"X" immediately after the "PLD" depends on the PLD where the
error was detected.
Display example: SYS PLD1 INITIAL ERROR
A SYS CPU communications fault was detected.
An SV CPU communications fault was detected.
An EQ CPU communications fault was detected.
An FC CPU communications fault was detected.
A communications fault with the 50-pin CPU was detected.
Note
The warning messages can be viewed in any menu except
the CUE or SET UP menu.