Info Menu (Display Only) - Epson EB-G5750WU User Manual

Info Menu (Display Only)

Lets you check the status of the image signals being projected and the status of the projector. Items that can be displayed vary depending on the image signal or
input source being projected as shown in the following screen shots.
RGB Signal/Component Video
Sub Menu
Lamp Hours
Source
Input Signal
Resolution
Video Signal
Refresh Rate
Sync Info
Status
Serial Number
Event ID
*1 The cumulative use time is displayed as "0H" for the first 10 hours. 10 hours and above is displayed as "10H", "11H", and so on.
g
Signal Composite video
You can display the cumulative lamp operating time
When it reaches the lamp warning time, the characters are displayed in yellow.
You can display the Source name for the connected equipment currently being projected.
You can display the content of Input Signal set in the Signal menu according to the Source.
You can display the Resolution.
You can display the content of Video Signal set in the Signal menu.
g
You can display the Refresh Rate
You can display the image signal information.
This information may be needed if service is required.
This is information about errors that have occurred on the projector.
This information may be needed if service is required.
Displays the projector's serial number.
When problems occur when the projector and computer are connected through the network, information on the problem is displayed using
an Event ID. Refer to the following page for information on interpreting the Event ID. s
g g
Signal/S-Video Signal
Function
*1 .
.
USB/LAN
p.92
75