Others Menu - Epson EB-G5750WU User Manual

Network Menu

Others Menu

Sub Menu
SNMP
Trap IP Address 1/Trap IP
Address 2
Priority Gateway
AMX Device Discovery
RoomView
Set this parameter to On when using SNMP
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a network
administrator.
When SNMP is set to On, you can set up to two IP addresses as SNMP trap notification destinations.
You can input a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
For the priority gateway, select either Wired or Wireless.
When the projector is connected to a network, set this to On to allow the projector to be detected by AMX Device Discovery
not connected to an environment controlled with a controller from AMX or AMX Device Discovery.
Set this parameter to On only when using Crestron RoomView
to Off. s "About Crestron RoomView®"
Changes in projector settings take effect upon restarting.
The following functions cannot be used when it is set to On.
• Web Control
• Message Broadcasting (EasyMP Monitor plugin)
Function
g
to monitor the projector.
®
to monitor and control the projector over a network. Normally, leave this parameter set
p.112
73
g
. Set this to Off if you are