Brinkmann professional Dual zone charcoal grill Owner's Manual page 14

Professional dual zone charcoal grill
Table of Contents

Advertisement

Available languages

Available languages

INS_810-3240-B_Eng-Frn.qxd
Grilling/Searing
Charcoal Grates
Low Charcoal Grates Level
(Grilling)
Charcoal Grates
Middle Charcoal Grates Level
(Grilling)
Charcoal Grates
High Charcoal Grates Level
(Searing)
13
3/14/05
6:28 PM
Page 14
Step 1
Lightly coat all interior surfaces of the Professional Dual Zone Grill
including cooking grills with vegetable oil or vegetable oil spray. Do not
coat charcoal grates or charcoal ash tray.
Step 2
Follow the instructions below carefully to build a fire. You may use
charcoal and/or wood as fuel in the Professional Dual Zone Grill (see
"Adding Charcoal/Wood During Cooking" section of this manual).
WARNING: Never use charcoal that has been pre-treated with lighter
If using a Charcoal Chimney Starter, follow all manufacturer's warnings
and instructions regarding the use of their product. Start with 8 to 10
pounds (3.6 to 4.5 kg) of charcoal. When charcoal is burning strong,
carefully place hot coals in center of each charcoal grate.
WARNING: DO NOT use grill without charcoal ash tray in place. DO NOT
NOTE:
If you choose to use charcoal lighting fluid, ONLY use charcoal lighting
fluid approved for lighting charcoal. Do not use gasoline, kerosene,
alcohol or other flammable material for lighting charcoal. Follow all
manufacturer's warnings and instructions regarding the use of their
product. Start with 8 to 10 pounds (3.6 to 4.5 kg) of charcoal. Place
the charcoal in center of each charcoal grate.
Step 3
Saturate charcoal with lighting fluid. With lid and doors open wait 2 to
3 minutes to allow lighting fluid to soak into charcoal. Store charcoal
lighting fluid safely away from the grill.
Step 4
With grill lid and doors open, stand back and carefully light charcoal
and allow to burn until covered with a light ash (approximately 20
minutes).
WARNING: Charcoal lighting fluid must be allowed to completely burn off
fluid. Use only a high grade plain charcoal or charcoal/wood
mixture.
attempt to remove charcoal ash tray while tray contains hot
coals.
To extend the life of your grill, make sure that hot coals and
wood do not touch the walls of grill.
IF USING CHARCOAL CHIMNEY STARTER, PROCEED TO STEP 5
prior to closing grill lid and doors (approximately 20
minutes). Failure to do this could trap fumes from charcoal
lighting fluid in grill and may result in a flash-fire or explosion
when lid is opened.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

810-3240-b

Table of Contents