I Partial Reset; I All Reset - Icom IC-R20 Instruction Manual

11
OTHER FUNCTIONS

I Partial reset

If you want to initialize the operating conditions (VFO fre-
quency, VFO settings, set mode contents) without clearing
the memory contents, a partial resetting function is available
for the receiver.
➥ While pushing [VFO MHz], turn the power ON to partially
reset the receiver.
DUALWATCH MAIN/SUB POWER
VFO MODE MR
BAND
MHz SCAN S.MW
DIAL.SEL SWEEP CENTER
1 2 3
SCOPE
T-SCAN SKIP M.N
4 5 6 0
AFC
TONE SET TS
7 8 9
LOCK
ATT RF GAIN IC Recorder
REC
67
POWER ON
AT
POWER
146 010
VFO
MHz
√
*The appearing frqeuency is
differ according to receiver
version.

I All reset

The function display may occasionally display erroneous in-
formation (e.g. when first applying power). This may be
caused externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a few
seconds, turn power ON again. If the problem persists, per-
form the following procedure.
• Partial resetting is also available. See left for details.
IMPORTANT!:
Resetting the receiver CLEARS all memory information
and initializes all values in the receiver, including TV chan-
nel skip setting.
➥ While pushing [VFO MHz] and [MR S.MW], turn the power
ON to reset the CPU.
DUALWATCH MAIN/SUB POWER POWER
MR
VFO MODE MR
BAND
MHz SCAN S.MW
S.MW
DIAL.SEL SWEEP CENTER
1 2 3
SCOPE VFO
MHz
T-SCAN SKIP M.N
4 5 6 0
AFC
TONE SET TS
7 8 9
LOCK
ATT RF GAIN IC Recorder
REC
POWER ON
AT
146 010
√
*The appearing frqeuency is
differ according to receiver
version.