I Priority Watch Operation - Icom IC-R20 Instruction Manual

8
PRIORITY WATCH

I Priority watch operation

D D Memory channel watch and memory scan watch
q Select VFO mode; then, set an operating frequency.
w Set the watching channel(s).
For memory channel watch:
Select the desired memory channel.
For memory scan watch:
Select memory mode, or the desired bank group; then,
push [MODE SCAN] for 1 sec. to start memory/bank scan.
e Push [8 SET] for 1 sec. to enter set mode.
rRotate [R-DIAL] to select "PRIORITY WATCH" item, then
push [8 SET].
tRotate [R-DIAL] to turn the priority watch ON, then push
[8 SET].
• Select "BELL" if the priority beep function is necessary.
43
[R-DIAL]
MODE
SCAN
MR
S.MW
SET
8
y Push [DUALWATCH] to exit set mode and start the watch.
• "PRIO" indicator appears.
• The receiver checks the memory/bank channel(s) every 5 sec.
• The watch resumes according to the selected scan resume con-
dition. (p. 41)
• During priority watch
439 975
√ µ 001
Monitors VFO frequency
for 5 sec.
• During priority watch with priority beep
439 975
√ µ 001
Emits beep and blinks "S" indicator when a signal is re-
ceived on a memory (bank) channel.
u Push [DUALWATCH] to cancel the watch.
145 870
√ µ 001
Pauses on a memory
(bank) channel when a
signal is received.
145 870
√ µ 001