Icom IC-R20 Instruction Manual page 51

D D VFO scan watch
q Select memory mode.
• Select a memory bank, if desired.
wPush [MODE SCAN] for 1 sec. to start memory/bank scan,
if desired.
While scanning memory/bank channels:
Starts memory/bank scan first. Memory/bank scan can-
not be started after VFO scan is started.
e Push [8 SET] for 1 sec. to enter set mode.
r Rotate [R-DIAL] to select "PRIO" item, then push [8 SET].
t Rotate to turn the priority watch ON, then push [8 SET].
• Select "BELL" if the priority beep function is necessary.
y Push [DUALWATCH] to exit set mode and start the watch.
• "PRIO" indicator appears.
uPush and hold [MODE SCAN] to enter scan type selection
condition.
iRotate [R-DIAL] to select the desired scan type from
"ALL," "BAND" and "PROG-xx
o Release [MODE SCAN] to start the VFO scan watch.
• The receiver checks the memory channel(s) every 5 sec.
• The watch resumes according to the selected scan resume con-
dition. (p. 41)
!0 Push [DUALWATCH] to cancel the watch and scan.
."
(xx= 0–24)
PRIORITY WATCH
• During priority watch
1888 888
√ µ 001
Monitors VFO frequency
for 5 sec.
• During priority watch with priority beep
1888 888
001
√ µ
Emits beep and blinks "S" indicator when a signal is re-
ceived on a memory (bank) channel.
8
145 870
√ µ 001
Pauses on a memory
(bank) channel when a
signal is received.
145 870
001
√ µ
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
44