I Memory/Bank/All Bank Scan - Icom IC-R20 Instruction Manual

7
SCAN OPERATION

I Memory/bank/all bank scan

q Select memory mode with [MR S.MW].
• Select the desired bank with [BAND] for bank scan.
w Set the squelch level.
eWhile pushing and holding [MODE SCAN], rotate [R-DIAL]
to select the desired scanning type.
• "ALL" for all bank scan; "BANK-LINK" for bank link scan or
"BANK-x" for bank scan. (x= A to Z; programmed bank groups
only displayed.)
37
• Full memory scan selection
[R-DIAL]
146 010
√ µ
MODE
SCAN
MR
• Band link scan selection
S.MW
√ µ 121
• Bank scan selection
√ µ A01
Selectable between "A" to "Z"
if programmed
r Release [MODE SCAN] to start the selected scan.
• Scan pauses when a signal is received.
• Rotate [R-DIAL] to change the scanning direction, or resumes
manually.
t To stop the scan, push [DUALWATCH].
• During memory/all/bank scan • During bank scan
888 800
√
088
IMPORTANT!: To perform memory or bank scan, 2 or
more memory/bank channels MUST be programmed, oth-
erwise the scan never starts.
888 800
µ 012 √ µ P01