Resetting; D Partial Reset - Icom IC-R30 Advanced Manual

7
OTHER FUNCTIONS

■ Resetting

Occasionally, erroneous information may be displayed. This may be caused by static
electricity or by other factors.
If this problem occurs, turn OFF the receiver. After waiting a few seconds, then turn it ON
again. If the problem still exists, perform a Partial reset, as described below.
If the problem still exists after a Partial reset, perform an All reset.
The resets affect the following:
Settings on the MENU screen, receive history log, operating settings in
Partial reset
the VFO mode will be reset to their default values.
Settings on the MENU screen, receive history log, operating settings in
All reset
the VFO mode, Memory channel contents, Programmable Scan edges
and GPS memories will be reset to their default values.
NOTE:
Before do a reset, make a backup of your setting data so you can reload it after the
reset.

D Partial reset

A Partial reset resets operating settings to their default values.
L The following settings
• Memory channels
• Programmable Scan edges
• GPS memories
[MENU] > Others > Reset > Partial Reset
1. Push [MENU].
2. Select "Partial Reset" in the "Others" menu.
(Rotate [DIAL] to select it, and then push [ENTER].)
• A confirmation dialog appears.
3. Select "YES," then push [ENTER].
• After resetting, the IC-R30 will automatically restart.
are not returned to their default values.
7-19