Checking, Disassembly And Reassembly Of The Control Panel - Robin America RGX7100 Service Manual

7-5.CHECKING,.DISASSEMBLY.and.REASSEMBLY.of.the.CONTROL.PANEL
7-5-1.CHECKING.OF.THE.CONTROL.PANEL
Dismount the control box assy from frame . Remove the control box from control panel and check
each components and wiring . Refer to Section 6 for the detail of checking procedure for the
components in the front panel .
7-5-2.DISASSEMBLY
(1) Remove the control panel from the control box .
(2) Disconnect the connectors on the wires to detach the control panel .
(3) After disconnecting individual wires, remove the control panel components .
7-5-3.REASSEMBLY
(1) Install the receptacles, circuit breakers, terminals, switches, etc . on the control panel and wire
them .
NOTE : C ircuit diagrams are shown in Section 9. Colored wires are used for easy identification,
and are of the correct capacity and size. Use heat-resistant type wires (permissible
temperature range 75°C or over) in the specified gauge shown in the circuit diagrams.
(2) Connect the wires of control panel components .
(3) Attach the control panel and control box to the Frame .
(Refer to 7-4-8 for details .)
- 48 -