Table of Contents
Advertisement
(3) Install the engine into the frame from the
side of it . Insert the bolt of mount rubbers
into the hole on the mount base . Tighten the
nuts over the mount rubber bolts to fix .
M10 flange nut . . . 2 pcs .
Tightening.torque.:.. . 24.0-30.0. N•m.
Tighten the temporally fixed bolt and nut for mount base .
M10 flange nut & M10 × 40 flange bolt . . . 1 pc .
Tightening.torque.:.. . 24.0-30.0. N•m.
NOTE : W hen tightening the nuts, slightly lift the engine so that the weight is not applied to the
mount rubbers.
7-4-2.FRONT.COVER
(1) Attach the N-bracket onto the front cover .
NOTE : M atch the rib direction on the N-bracket
with the top mark on the front cover
surface.
M8 × 20 flange bolt . . . 4 pcs .
Tightening.torque.:.. . 16.5-20.5. N•m.
.240-300. kgf•cm.
.(17.8-22.2.ft•lbs)
.240-300. kgf•cm.
.(17.8-22.2.ft•lbs)
.165-205. kgf•cm.
.(12.2-15.2.ft•lbs)
BOLT
N-BRACKET
A
TOP mark
- 38 -
ENGINE
BOLT
RIB
FRONT
COVER
View A
Advertisement
Table of Contents
