Robin America RGX7100 Service Manual page 45

(6) Set the Mount Rubber bolts into the Mount
Base holes .
Don't tighten the nut at this moment .
(7) Install the brush holder, AVR unit and diode
stack in the rear cover .
M5 × 16 bolt . . . 2 pcs . (AVR unit)
Tightening.torque.:.. . 4.0-4.5.
M5 × 16 bolt . . . 2 pcs . (brush holder)
M4 × 18 bolt . . . 1 pc . (diode stack)
Tightening.torque.:.. . 1.5-2.0.
NOTE : I f the brush is installed oblique to the
slip ring, there is possibility that the
brush holder can break when the screw
is tightened : or the brush may break
when generator of started. Make this
process carefully.
(8) Attach the connectors to the brush holder,
AVR unit and diode stack .
(9) Connect the earth (ground) wire (green/
yellow) with the rear cover with screw .
(10) Connect earth (ground) wire between
frame and rear cover .
On frame side: M6 × 12 bolt . . . 1 pc .
On rear cover side: 8mm nut
(commonly tighten the mount rubber bolt)
N•m.
.40-45. kgf•cm.
(3.0-3.3. ft•lbs)
N•m.
.15-20. kgf•cm.
(1.1-1.5. ft•lbs)
REAR COVER
BRUSH
HOLDER
AVR UNIT
A.V.R..type.(A)
A.V.R..type.(B)
EARTH
(GROUND)
WIRE
SCREW
BRUSH
HOLDER
EARTH (GROUND) WIRE
- 41 -
MOUNT RUBBER
FLANGE NUT
DIODE
STACK
Wiring.color.
Plus.⊕. Minus.⊖
Blue Yellow
Red White
Brown
White
Black
Brown
EARTH
(GROUND)
WIRE
DIODE
STACK
AVR UNIT