Table of Contents
Advertisement
7-4-5.REAR.COVER
(1) Put the rear cover over the rotor .
Pull out the stator wirings through the
opening of the rear cover .
NOTE : B e careful not to give cuts to wires
when pulling them out from the rear
cover.
(2) Tap on the rear cover evenly with a plastic
hammer to press the rotor bearing into the
rear cover .
(3) Fix the rear cover with bolts .
NOTE : T ighten the bolts evenly and in turns.
M6 × 180 flange bolt . . . 4 pcs .
Tightening.torque.:.. . 6.5-8.5.
(4) Temporally attached the Muffler Bracket 1
to the Rear Cover .
M8 × 16 flange bolt . . . 1 pc .
(5) Temporally assemble the Mount Base to
the Rear Cover by inserting flange bolt into
middle hole on Mount Base, Rear Cover
hole and Muffler Bracket 1 hole .
Temporally fix the bolt by nut .
NOTE : M eet other side hole on the Mount
Base with hole of Rear Cover.
(Refer to right side picture)
M10 flange nut &
M10 × 40 flange bolt . . . 1 pc .
N•m.
.65-85.
kgf•cm.
(4.8-6.3.
ft•lbs)
REAR COVER
MUFFLER
BRACKET 1
- 40 -
REAR COVER
MOUNT BASE
PLASTIC
HAMMER
Advertisement
Table of Contents
