O O P P T T I I O O N N A A L L V V E E H H I I C C L L E E R R E E C C O O V V E E R R Y Y S S Y Y S S T T E E M M ( ( V V R R S; F F A A L L S S E E A A L L A A R R M M C C O O N N T T R R O O L L T T E E C C H H N N O O L L O O G G Y Y ( ( F F A A C C T - Clifford Matrix 1 Installation Manual

H1/7 VIOLET (+) door trigger input
This type of dome circuit is used in many Ford products. Connect the violet wire to a wire that shows
(+)12V when any door is opened. This wire will report Zone 3.
NOTE: If using a door trigger wire that has a delay, Advanced Menu 2, feature 6 or the 998T
Bitwriter can be used to turn Bypass Notification off.
H1/8 BLACK (-) chassis ground connection
Connect this wire to a clean, paint-free sheet metal location (driver kick panel) using a factory bolt
that DOES NOT have any vehicle component grounds attached to it. A screw should only be used
when in conjunction with a two-sided lock washer. Under dash brackets and door sheet metal are
not acceptable ground points. It is recommended that all security components be grounded at the
same location.
H1/9 YELLOW (+) ignition input
Connect this wire to the (+) 12 volts ignition wire. This wire is pre-wired to the starter kill relay and
must show (+) 12 volts with the key in RUN position and during cranking. Take great care that this
wire cannot be shorted to the chassis at any point.
8
© 2005
Directed Electronics, Inc. all rights reserved