Clifford Matrix 1 Installation Manual page 27

2. Turn on the ignition.
3. Release the Valet/Program switch.
4. Press and release the Valet/Program switch within 5 seconds. The LED will
flash in groups indicating the last two zones that triggered the unit. The LED
will flash for one minute or until the ignition is turned off.
NOTE: The Warning Zone triggers are not stored to memory and will not be reported.
Multi-Level Security Arming
Multi-Level Security Arming is only available when using an optional Radar Master transmitter that
has been configured with separate transmitter buttons for arming and disarming. Multi-Level Security
Arming allows you to select which of the system's inputs or sensors will be active or bypassed at the
time that the system is armed. (See Table of Zones section.) Pressing the arm button again within five
seconds of arming the system will activate Multi-Level Security Arming. Each time the arm button is
pressed again, a different security level is selected. The different security levels can be selected as follows:
➤ ➤ Pressing the arm button once: The siren chirps once. The system is armed.
➤ ➤ Pressing the arm button twice within five seconds: The siren chirps twice followed by a long
chirp. Zone Two is now bypassed.
➤ ➤ Pressing the arm button a third time within five seconds: The siren chirps three times followed
by a long chirp. Zone Four is now bypassed.
➤ ➤
Pressing the arm button a fourth time within five seconds: The siren chirps four times followed
by a long chirp. Zones Two and Four are now bypassed.
➤ ➤
Pressing the arm button a fifth time within five seconds: The siren chirps five times followed by
a long chirp. All input zones, except the ignition, are now bypassed.
NOTE: Multi-Level Security Arming only applies to a single arming cycle. Once the system is
disarmed and then re-armed, all the zones will be active again.
www.clifford.com
27