Mounting; Orientation; Rigging; Procedure - Chauvet Rogue User Manual

Mounting

Orientation

Rigging

Procedure

Mounting Diagram
Rogue™ R2 Beam User Manual Rev. 2
Before mounting this product, read and follow the
mounting clamps, go to http://trusst.com/productcategory/base-plates-accessories-clamps/.
Always mount this product in a safe position and make sure there is adequate room for
ventilation, configuration, and maintenance.
CHAUVET® recommends using the following general guidelines when mounting this product.
·
When selecting an installation location, consider easy access to this product for operation,
programming adjustments, and routine maintenance.
·
Make sure to mount this product away from any flammable material as indicated in the
Safety Notes.
·
Never mount in places where rain, high humidity, extreme temperature changes, or
restricted ventilation may affect the product.
·
If hanging this product, make sure that the mounting location can support the product's
weight. See the Technical Specifications
product.
·
When hanging this product, always secure to a fastening device using a safety cable (such
as CH-05 from CHAUVET®).
The Rogue™ R2 Beam comes with a preinstalled mounting surface to which you will be able to
attach the 2 included omega brackets. Make sure the clamps (such as CLP-15 from
CHAUVET®) are capable of supporting the weight of this product. Use two mounting points per
product. In addition, use a safety cable to link the product to the structure.
Floor Mounting
Safety
for the weight-bearing requirements of this
Mounting Clamp
Safety Cable
Omega Brackets
Mounting
Surface
Overhead Mounting
Notes. For our CHAUVET® line of
Setup
-11-