Procedure (Cont.) - Chauvet Rogue User Manual

Procedure
(Cont.)
Rogue™ R2 Beam User Manual Rev. 2
4. Remove the 2 Phillips-head screws on the sides of the fan assembly.
5. Roll the fan assembly to the right to expose the lamp.
6. Using the lamp base, push the lamp down against the spring clips located on the
bottom, then roll the lamp out the top.
7. Remove the 2 wires connected to the lamp by the spade terminals.
8. Reverse the steps above to install the new lamp. Do not touch the glass with bare
hands.
Do not turn product on without a lamp!
Setup
-9-