Increasing The Lamp's Life; Lamp Adjustment - Chauvet Rogue User Manual

Setup
Increasing the Lamp's

Lamp Adjustment

-10-
· ALWAYS turn the lamp off by using the DMX controller or the product's control
panel, then wait at least 5 minutes before switching off the product. This will
Life
keep the fans running to extract any remaining heat from the product's head.
· DO NOT power cycle the product unless it is necessary.
· DO NOT re-strike the lamp immediately after turning it off. CHAUVET®
recommends waiting 5 minutes before trying to re-strike the lamp.
· DO NOT touch the lamp without wearing gloves to avoid leaving grease on the
bulb or on the contacts that could reduce the lamp's life.
· ALWAYS change the lamp when it has reached its recommended lifespan to
avoid the risk of lamp explosion.
The Rogue™ R2 Beam allows for lamp adjustment or "bench focusing". Follow the
procedure below to safely adjust the lamp.
1. Follow steps 1 and 2 of the
2. After connecting the product to power, turn product on.
3. Using DMX or as explained in
head so that the fan is facing upward.
4. Locate the Adjustment Screw as indicated in the figure below:
Adjustment
Screw
5. Turn the Adjusting Screw while viewing the light on a flat white surface to find desired
focus.
6. Turn the product off and disconnect it from power. Wait at least 15 minutes for the
lamp to cool down.
7. Re-attach both head covers by replacing all 8 Phillips-head ¼-turn screws.
Lamp Replacement procedure.
Manual Test section, orient the bottom of the moving
Rogue™ R2 Beam User Manual Rev. 2