Lamp Settings - Chauvet Rogue User Manual

Operation

Lamp Settings

Turning the Lamp
On/Off
Lamp State This option determines whether the lamp turns on automatically when the product is powered
Remote Turn Off This option allows a connected DMX controller to turn the lamp on/off via the control channel.
Lamp On if DMX
Present
Lamp Off if DMX
Absent
Lamp Strike Delay This option sets the duration of time (seconds) it takes for the lamp to turn on when powering up
Lamp Low Power
State
Lamp Timer This procedure resets the lamp maintenance timer to 0. It is recommended that this be done
-18-
This programming level allows the user to change a range of options that control the action of
the lamp.
·
Starting from the Setup screen level, select Lamp Settings, press <ENTER>.
This option turns the lamp on and off.
1. Highlight On/Off, press <ENTER>.
2. Select ON or OFF, press <ENTER>.
· Do not turn product on without a lamp!
· ALWAYS turn the lamp off by using the DMX controller or the product's control
panel, then wait at least 5 minutes before switching off the product. This will keep
the fans running to extract any remaining heat from the product's head.
· DO NOT power cycle the product unless it is necessary.
· DO NOT re-strike the lamp immediately after turning it off. CHAUVET® recommends
waiting 5 minutes before trying to re-strike the lamp.
up.
1. Highlight State/Power on, press <ENTER>.
2. Select ON or OFF, press <ENTER>.
1. Highlight Off Via Dmx, press <ENTER>.
2. Select YES or NO, press <ENTER>.
This option determines whether the lamp turns on automatically when a DMX signal is detected.
1. Highlight On If Dmx On, press <ENTER>.
2. Select YES or NO, press <ENTER>.
This option determines whether the lamp turns off automatically when a DMX signal is lost.
1. Highlight Off If Dmx Off, press <ENTER>.
2. Select YES or NO, press <ENTER>.
the product.
1. Highlight Ignition Delay, press <ENTER>.
2. Select 000–255, press <ENTER>.
This attribute puts the lamp into a low power state when the shutters are closed helping to
increase the life of the shutters. This option allows the user to adjust how long from the instant
the shutters are closed to the time the lamp enter the low power state.
1. Highlight Low Power Delay, press <ENTER>.
2. Select 000–255, press <ENTER>.
after every lamp change.
1. Highlight Reset Lamp Time, press <ENTER>.
2. Select 010–250, press <ENTER>.
Rogue™ R2 Beam User Manual Rev. 2