Product At A Glance; Safety Notes; Personal Safety; Mounting And Rigging - Chauvet Rogue User Manual

Before You Begin
Product At A
Glance

Safety Notes

Personal Safety

Mounting And
Rigging
Power And
Wiring

Operation

-2-
Use on Dimmer
Outdoor Use
Sound-Activated
DMX
Master/Slave
Read all the following Safety Notes before working with this product. These notes include
important information about the installation, usage, and maintenance of this product.
This product contains no user-serviceable parts. Any reference to servicing in this
User Manual will only apply to properly trained CHAUVET® certified technicians. Do
not open the housing or attempt any repairs.
All applicable local codes and regulations apply to proper installation of this product.
·
Avoid direct eye exposure to the light source while the product is on.
·
Always disconnect this product from its power source before servicing.
·
Always connect this product to a grounded circuit to avoid the risk of electrocution.
·
Do not touch this product's housing during operation because it may be very hot.
·
This product is for indoor use only! To prevent risk of fire or shock, do not expose this
product to rain or moisture. (IP20)
·
Mount this product in a location with adequate ventilation, at least 20 in (50 cm) from
adjacent surfaces.
·
This product weighs 45 lb (20.6 kg). Always ask for help when mounting this product to
avoid personal injuries or damage to the product.
·
Make sure there are no flammable materials close to this product while it is operating.
·
Always carry this product by the handles. Do not carry from the head.
·
When hanging this product, always secure to a fastening device using a safety cable.
·
Always make sure you are connecting this product to the proper voltage in accordance
with the specifications in this manual or on the product's specification label.
·
Never connect this product to a dimmer pack or rheostat.
·
Never disconnect this product by pulling or tugging on the power cable.
·
Do not operate this product if you see damage to the housing, lenses, ultraviolet filter, or
cables. Have the damaged parts replaced by an authorized technician at once.
·
Do not cover the ventilation slots when operating to avoid internal overheating.
·
Do not aim this product toward the Sun. The lenses could concentrate the solar energy
and cause internal overheating.
·
The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at a
higher temperature.
·
In case of a serious operating problem, stop using this product immediately!
In the unlikely event that your CHAUVET® product may require service, contact
CHAUVET® Technical Support.
x
Auto Programs
Auto-Ranging Power
x
Supply
x
Replaceable Fuse
P
User-Serviceable
x
x
P
P
x
Rogue™ R2 Beam User Manual Rev. 2