Wlan Module - HP TouchSmart 9100 Maintenance And Service Manual

17. Pull the card away from the I/O cover (4) and remove it from the computer.
To install the graphics card, reverse the removal procedures.
Before reinstalling the system board shield, make sure the small EMI shield near the hard drive is
correctly installed.
When reinstalling a discrete graphics card, be sure to remove all old thermal material and apply new
thermal material.
When installing a new discrete graphics card, be sure to apply thermal material.

WLAN module

1. Prepare the computer for disassembly (see
on page
2. Place the computer face down on a soft, flat surface.
3. Remove the hard drive/memory cover (see
4. Remove the stand (see
5. Remove the I/O cover (see
6. Remove the feet (see
7. Remove the back cover (see
8. Remove the amp board shield (see
12).
Stand on page
I/O cover on page
Feet on page
Back cover on page
Preparing to disassemble the HP TouchSmart PC
Hard drive/memory cover on page
17).
15).
16).
22).
Amp board shield on page
14).
28).
WLAN module
31