Adding Memory; Before You Begin; Removing A Memory Module; Prepare The Computer For Disassembly (See Preparing To Disassemble The Hp Touchsmart Pc - HP TouchSmart 9100 Maintenance And Service Manual

5. Lift the stand straight up and off the computer.
To install the stand, reverse the removal procedures.
When installing the stand, make sure the two tabs fit into the slots in the computer so the stand sits flush
on the back of the computer.

Adding Memory

The HP TouchSmart PC comes with random access memory (RAM), which temporarily stores data and
instructions on your computer. The HP TouchSmart PC ships with one or two memory modules that you
can replace.

Before you begin

Observe the following requirements before removing and replacing the memory module.
The motherboard contains sockets for SODIMMs (small outline dual in-line memory modules).
To determine which type and speed of memory module your HP TouchSmart PC uses, and for specific
memory module information and specifications, go to
CAUTION:

Removing a memory module

1. Prepare the computer for disassembly (see
on page
2.

Place the computer face down on a soft, flat surface.

18 Chapter 4 Removal and Replacement Procedures
Using the wrong type of memory module could damage the computer.
12).
http://www.hp.com/support
Preparing to disassemble the HP TouchSmart PC