Table of Contents
Advertisement
WLAN module
The wireless module is secured to the system board and has one antenna cable connected.
To remove the WLAN module:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Disconnect the WLAN antenna cable from the terminal labeled "1" on the WLAN module.
4.
Remove the Phillips screw that secures the WLAN module to the system board. (The edge of the module
opposite the slot rises away from the computer.)
5.
Remove the WLAN module by pulling the module away from the slot at an angle.
NOTE:
Reverse this procedure to install the WLAN module.
20
Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Access panel on page
WLAN modules are designed with a notch to prevent incorrect insertion.
(Preparation for disassembly on page
15).
14).
Advertisement
Table of Contents
