Computer Setup-Boot - HP TouchSmart 9100 Maintenance And Service Manual

Table 5-4
After AC Power
Failure
XD (Execute Disable) Disables/enables the processor's XD feature.
Virtualization
Technology
S5 Maximum Power
Savings
WOL in S5
Computer Setup—Boot
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 5-5
Option
Boot-time Diagnostic
Screen
Esc: Boot Menu
F9: Diagnostics
F10: Setup
F11: Recovery
F12: Boot From LAN
(Boot Device
Priority)
1st Boot Device
2nd Boot Device
3rd Boot Device
4th Boot Device
Floppy Group Boot
Priority
54 Chapter 5 Computer Setup (F10) Utility
Computer Setup—Power (continued)
Allows you to select system restart behavior after power loss:
●
Stay Off
●
Power On
●
Auto
Allows you to disable/enable Virtualization Technology.
Disables/enables S5 Maximum Power Savings. Enabling this feature reduces the power of this
system as much as possible in the S5 state. This feature must be disabled if you want to enable
Wake on LAN from S5.
Disables/enables limited Wake on LAN from S5. Note that the computer can only wake from S5
during a normal shutdown event. The S5 Maximum Power Savings feature must be disabled in
order to enable limited Wake on LAN from S5.
Computer Setup—Boot
Description
Disables/enables POST diagnostic messages display.
Disables/enables POST Esc: Boot Menu message display,
Disables/enables POST F9: Diagnostics message display,
Disables/enables POST F10: Setup message display,
Disables/enables POST F11: Recovery message display,
Disables/enables POST F12: Boot From LAN message display,
Allows you to specify which device groups will boot first, second, third, and fourth or to disable any
of the four:
●
CD-ROM Group
●
HDD Group
●
Floppy Group
●
Network Boot Group
NOTE: MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating system
has started.
Specifies boot device priority within removable devices.