Tv Tuner Module - HP TouchSmart 9100 Maintenance And Service Manual

9. Remove the system board shield (see
10. Disconnect the two antenna cables from the module (1).
11. Remove the two screws that secure WLAN module to the system board (2).
12. Lift the module up to a 45 degree angle, and then remove it from the slot at an angle.
To install the WLAN module, reverse the removal procedures.
WLAN modules include a notch that prevents incorrect installation.

TV tuner module

1. Prepare the computer for disassembly (see
on page
2. Place the computer face down on a soft, flat surface.
3. Remove the hard drive/memory cover (see
4.
Remove the stand (see
5. Remove the I/O cover (see
6. Remove the feet (see
7. Remove the back cover (see
8. Remove the amp board shield (see
9. Remove the system board shield (see
32 Chapter 4 Removal and Replacement Procedures
12).
Stand on page
I/O cover on page
Feet on page
Back cover on page
System board shield on page
Preparing to disassemble the HP TouchSmart PC
Hard drive/memory cover on page
17).
15).
16).
22).
Amp board shield on page
System board shield on page
28).
14).
28).
28).