Wlan Module - HP EliteDesk 880 G5 Maintenance And Service Manual

WLAN module

The WLAN module installs into a slot on the system board.
For a list of available WLAN modules, see
To remove the WLAN module:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the power and data cables from the rear of the drives in the drive cage.
5. Rotate the drive cage up (see
6. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2".
7. Remove the Phillips PM2.0×3.0 screw (2) that secures the WLAN module to the computer. (The edge of
the module opposite the slot rises away from the computer.)
8. Remove the WLAN module (3) by pulling the module away from the slot at an angle.
NOTE:
Reverse this procedure to install the WLAN module.
62 Chapter 4 Removal and replacement procedures
(Access panel on page
(Front bezel on page
Drive cage on page
The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled "1".
WLAN modules are designed with a notch to prevent incorrect insertion.
Computer major components on page
(Preparation for disassembly on page
18)
19).
29)
5.
17)