Commands For Ip Process - IBM ADSL Bridge/ Router Heritage User Manual

Heritage Series ADSL Bridge/ Router
Command Sets for Command Line Interface
Syntax:
ip device add <i/f> <type> <file> [mtu <size>] [<IP
address>|dhcp]
ip device
Description:
The ip device add command adds an interface to the configuration of
the IP stack. The last parameter of the command would normally the
IP address of the interface; use of the string dhcp causes the IP
address to be discovered by the DHCP client software. Note that
using the flag dhcp on an interface precludes running a DHCP server
on that interface! The ip device command lists the current
configuration of any devices attached to the IP stack. A device
configured to use DHCP will show
followed by the actual IP address discovered and bound by DHCP, if
any. For interfaces configured to use DHCP, saving configuration
only marks the interface as using DHCP; it does not save the actual IP
address discovered by DHCP, which must be renewed.
Example:
DSL> ip device add ethernet ether //edd dhcp
...DHCP then discovers the IP address for the interface...
DSL> ip device
# type dev file IP address
device ethernet ether //edd mtu 1500 dhcp

Commands for IP process

p" in the
"dhc "IP addres
7-19
s" column,