Table of Contents
Advertisement
Heritage Series ADSL Bridge/ Router
Command Sets for Command Line Interface
assumed. Providing an SVC setting unsets any PVC setting. See the
command.
pvc
Configuration saving saves this information. By default a channel has
no connection information.
Example:
> ppp 3 svc
47.00.83.01.03.00.00.00.00.00.00.00.00.00.00.20.2b.00.03.0b.00
> ppp 4 svc listen
> ppp 7 svc none
19. <channel> theylogin
Syntax:
<channel> theylogin pap|chap|none
Description:
This command describes how we require the far end to log in on this
channel. Requiring the other end to log in most frequently happens
when they dial us (rather than the other way round), so this is likely
to be one of several channels which are set using
of this, exact names and passwords are not attached to individual
channels but are matched to particular users, as defined using the
command. This command specifies that when using this channel,
user
the user must log on using the specified protocol, and that they must
provide any name/password combination which has been defined for
that protocol, using the
on a channel, call
Configuration saving saves this information. By default no login is
required.
20. <channel> welogin
Syntax:
<channel> welogin <name> <password> [pap|chap]
<channel> welogin none
Description:
This command describes how we should log in to the far end when a
connection is established.
A name and password are supplied, and whether these should be
used with the PAP or CHAP authentication protocol. CHAP is the
default. To remove this information on a channel, call
single argument of
if the other end prefers this. If
pap
using
.
pap
;listen for incoming call
;tear down connection, remove setting
command. To remove this information
user
with a single argument of
theylogin
. If
is specified, we will also log in using
none
chap
is specified we will only log in
pap
7-49
. Because
svc listen
none.
with a
welogin
Advertisement
Table of Contents
