Task 6: Preparing The San Router For Element Manager Access; Set The Ip Address For The Network Management Port Using Cli; Terminal Emulator Settings; Management Port To Management Terminal Connection - IBM TotalStorage SAN16M-R SAN Installation And Service Manual

Figure 4

Task 6: Preparing the SAN Router for Element Manager access

Set the IP address for the network management port using CLI

1
CONSOLE

Management port to management terminal connection

2. Set the PC terminal emulator settings to the SAN Router default
settings shown below in

Terminal emulator settings

Table 10
Parameter
Bits per second
Data bits
Parity bits
Stop bits
Flow Control
Ensure that the VT100 arrow emulation feature is on.
The SAN Router has a 10/100 Management Port IP address. You
need to configure the SAN Router inband IP address. You do not
need to change the 10/100 Management Port IP Address for Element
Manager Access, but it must be set to an IP address appropriate for
Chapter 2: Installing and connecting the SAN Router
Table 10, Terminal emulator
Setting
9600
8
None
1
None
settings.
21