Table of Contents
Advertisement
Command Sets for Command Line Interface
7-46
parameter negotiation is not converging. Call with no argument to
find the current setting.
The default value is 5. Configuration saving saves this information.
13. <channel> lcpmaxterminate
Syntax:
<channel> lcpmaxterminate [<n>]
Description:
Set the Max-Terminate parameter for LCP. This is the maximum
number of Terminate Requests that will be sent without reply, before
assuming that the peer is unable to respond. Call with no argument to
find the current setting.
The default value is 2. Configuration saving saves this information.
14. <channel> llc
Syntax:
<channel> llc [1|0]
Description:
If 1, use an LLC header on the front of transmitted packets and
require one on received ones. This consists of four bytes, FE-FE-03-CF,
and is required for PPP Over AAL5 (RFC 2364 p4) when using LLC
encapsulated PPP. If 0, disable this. Call with no argument to find the
current setting.
The default value is 0 (disabled). Configuration saving saves this
information.
If not set, and a packet is received with an LLC header, the channel
goes into a 'learned LLC' mode and sends packets with the LLC
header. Thus, interoperation with LLC-using equipment should not
normally require any configuration. Learning occurs in this direction
only. Setting
hdlc
Configuration saving does not save the learned state.
15. <channel> pvc
Syntax:
<channel> pvc [[<port>] <vpi>] <vci> [ip|mac] [listen]
<channel> pvc none
Description:
Attach an ATM PVC to the given PPP channel. The port can be
specified (only for a multi-port device), and the VPI (default is 0), and
the VCI. The allowable range of port, VPI, VCI depends on the ATM
to 0 clears this learned state.
Advertisement
Table of Contents
