Table of Contents
Advertisement
Heritage Series ADSL Bridge/ Router
The following command tell you how to adding a Network Address
Translation protocol to the Classic IP(RFC1577) or PPP over ATM(RFC2364)
or PPP over Ethernet(RFC2516) configuration that mentioned above. The
following command must be added after the "ip device add ..."
commands have been given and the Router restarted.
Enables NAT on a Classic IP (RFC1577)
> ip nat add ipoa ↵
Enables NAT on a PPP over ATM (RFC2364) or PPP over Ethernet
(RFC2516)
> ip nat add ppp_device ↵
Advanced Configurations
4-3
Advertisement
Table of Contents
