Table of Contents
Advertisement
Heritage Series ADSL Bridge/ Router
for DHCP clients.
filename
filenam
filename "
e";
The
statement can be used to specify the name of the initial boot
filename
file which is to be loaded by a client. The filename should be a filename
recognizable to whatever file transfer protocol the client can be expected to
use to load the file.
server-name
nam
server-name "
e";
The
statement can be used to inform the client of the name of
server-name
the server from which it is booting.
provided to the client.
next-server
next-server
server-nam
The next-server statement is used to specify the host address of the server
from which the initial boot file (specified in the filename statement) is to be
loaded. Server-name should be a numeric IP address or a domain name. If
no next-server parameter applies to a given client, the DHCP server's IP
address is used.
fixed-address
IP-address
fixed-address
The fixed-address statement is used to assign one or more fixed IP
addresses to a client. It should only appear in a
than one address is supplied, then when the client boots, it will be assigned
the address which corresponds to the network on which it is booting. If
none of the addresses in the
which the client is booting, that client will not match the
containing that
fixed-address
dynamic-bootp-lease-cutoff
dynamic-bootp-lease-cutoff
The
dynamic-bootp-lease-cutoff
assigned dynamically to BOOTP clients. Since BOOTP clients have no way
of renewing leases, and do not know that their leases could expire, the
DHCP server assigns infinite leases to BOOTP clients. However, it may
make sense in some situations to set a cut-off date for all BOOTP leases.
DHCP Server Operation
should be the name that will be
Name
e;
IP-address
[,
... ];
host
statement are on the network on
fixed-address
statement.
dat
e;
statement sets the ending time for all leases
8-9
declaration. If more
declaration
host
Advertisement
Table of Contents
