Clifford Concept 450 Installation Manual page 29

N N O O T T E E : : When programming a new remote control to custom configuration a channel
must first be programmed to this feature before programming the remaining channels.
accessory a output
The transmitter channel programmed into this feature will activate the accessory
output.
accessory b output
The transmitter channel programmed into this feature will activate the accessory
output.
silent mode
The transmitter channel programmed into this feature will arm/disarm the
system, but the siren will not chirp.
remote valet
The transmitter channel programmed into this feature will make the system
enter/exit valet mode.
remote start
This feature is only available with IntelliStart connected
The transmitter channel programmed into this feature will activate or shut down
the Intellistart remote start system.
window control
This feature is only available with SmartWindows connected
The transmitter channel programmed into this feature will activate the vent or roll
down feature of the SmartWindows system.
clear all remotes
This feature will erase all remote codes from the system memory. This feature is
convenient for erasing any transmitters that have been lost, stolen, or incorrect-
ly programmed into the system.
After entering this feature press any button on the transmitter; the siren will chirp
to indicate that all transmitters have been erased from memory.
© 2004 directed electronics, inc.
27