Installation Of An Nxd Touch Panel; Installing The Nxd Panel Within A Conduit Box - AMX NXD-CV7 Instruction Manual

Installation
3. Remove the wiring knockouts from the left side of the conduit box (CB-TP7)
(FIG. 34) to accommodate the cables being threaded through to the NXD touch panel.
Remember that when mounting this conduit box, the NXD mounting tabs must lie
flush against the outside of the sheetrock.
4. Thread the incoming power, RJ-45 audio/video, Ethernet, and USB wiring through the
knockouts (use of the left wiring knockouts are recommended with this installation).
Leave enough slack in the wiring to accommodate any re-positioning of the panel.
5. Install the drywall/sheetrock before inserting the main NXD unit into the CB-TP7.

Installation of an NXD Touch Panel

The NXD-CV7 can be installed either directly into the (optional) CB-TP7 or other solid surface
environment using the two different mounting options: drywall clips or solid surface screws. The
following sections describe mounting the touch panel directly into a pre-wall conduit box, a solid
surface or drywall, and optional NXA-RK7 Rack Mount Kit for installation.

Installing the NXD panel within a Conduit Box

The conduit box must be mounted prior to continuing this section. Refer to the procedures in the
Pre-Wall Installation of the Conduit Box section on page 33 for detailed pre-wall installation
instructions. Verify that all necessary cables have been threaded through the knockouts on the left of
the conduit box and the connections have been tested prior to installation of the NXD-CV7.
1. Remove the Faceplate/bezel (A in FIG. 35) from the main NXD unit
(B in FIG. 35) by gripping the faceplate and pulling with gentle outward force.
#4-40 Mounting Screws
secure the NXD to
FIG. 35 NXD-CV7 panel installation into a CB-TP7 (pre-wall construction)
34
(four - included)
the Conduit Box
A - Faceplate/Trim Ring
default Faceplate comes with buttons
C - Optional CB-TP7
conduit/wallbox
Mounting Tab
B - Main NXD unit consists of
the touch panel and back box housing
7" Modero Widescreen Touch Panels
Stud