Step 2: Upgrading Internal Components (Compact Flash And Wireless Cards) - AMX NXD-CV7 Instruction Manual

8. In a single motion, carefully pull both the Tilt Bracket cover plate and outer housing up and
then out (away from the LCD panel) to expose the internal circuit board (FIG. 17).
Outer Housing
FIG. 17 Removal of the outer housing and wireless card location

Step 2: Upgrading internal components (Compact Flash and Wireless cards)

1. Discharge any static electricity from your body by touching a grounded metal object.
2. Locate the 64 MB Compact Flash and Wireless Interface cards on the main board (FIG. 18).
Front of panel
Compact Flash Card
Card Removal Grooves
FIG. 18 Location and orientation of the card slots (both CV7 panels)
3. Insert a grounded flathead screwdriver into one of the card removal grooves (located on either
side of the card), and gently pry the card up and off the connector pins. Repeat this process on
the opposite card removal groove. This alternating action causes the card to "wiggle" away
from the on-board connector pins.
4. Slip your finger into the opening between the connector pins and the card, and push the card
out to remove it.
5. Remove the upgrade card from it's anti-static bag.
7" Modero Widescreen Touch Panels
(Slot 1)
Tilt Bracket cover plate
(must be removed first)
Outer housing
installation holes
(located on front panel)
Base
CV7 Touch Panel Accessories
Tilt Bracket
Wireless Interface Card
(Slot 2)
Card removal grooves
17