Step 2: Configure The Card's Wireless Security Settings; Configuring The Modero's Wireless Card For Unsecured Access To A Wap200G - AMX NXD-CV7 Instruction Manual

Step 2: Configure the Card's Wireless Security Settings

The second step to successfully setting up your wireless card is to configure the Wireless Settings
section of the Secondary Connection page. The section configures both the communication and
security parameters from the internal wireless card to the WAP. The procedures outlined within the
following sections use an NXA-WAP200G and the target WAP.
Once you have completed setting up the wireless card parameters, you must then
navigate to the System Connection page and configure the communication
parameters for the target Master. Until those parameters are configured, your
Connection Status icon will remain red (indicating that there is no current connection
to a Master).

Configuring the Modero's wireless card for unsecured access to a WAP200G

Prior to beginning the configuration of the wireless settings, verify that the panel has
been upgraded to a wireless panel via the installation of the NXA-WC80211B/CF
wireless interface card.
1. Power-down the Modero unit and follow the wireless card installation procedures outlined in
the Installation of the Wireless Card (Table Top Panel) section on page 15.
2. Power-up the panel (this allows it to detect the card).
3. Press the Protected Setup button (located on the lower-left of the panel page) to open the
Protected Setup page and display an on-screen keypad.
4. Enter 1988 into the Keypad's password field and press Done when finished.
5. Press the Secondary Connection button (located on the lower-left) to open the Secondary
Connection page.
6. From within the Wireless Settings section of the Secondary Connection page, touch the
Network Name (SSID) field (FIG. 57).
FIG. 57 Secondary Connection page (showing default values)
7. From the Service Set Identifier keyboard, enter the SSID name used on your target Wireless
Access Point (case sensitive).
7" Modero Widescreen Touch Panels
The card should be given the SSID used by the target WAP. If this field is left blank, the
unit will attempt to connect to the first available WAP. By default, all WAP200Gs use
AMX as their assigned SSID value.
Configuring Communication
Wireless card
settings
59