Calibration Page; Secondary Connection Page - AMX NXD-CV7 Instruction Manual

Calibration Page

This page (FIG. 92) allows you to calibrate the touch panel using the pre-selected touch driver.
FIG. 92 Calibration page (actually 3 separate screens)
If the calibration was improperly set and you cannot return to the Calibration
page (through the panel's firmware); you can access this firmware page via
G4 WebControl where you can navigate to the Protected Setup page and press the
Calibrate button through your VNC window.
This action causes the panel to go to the Calibration page seen above, where you
can physically recalibrate the actual touch panel again using the above procedures.

Secondary Connection Page

The Secondary Connection page (FIG. 93) sets the communication information for the installed
wireless interface card. This information includes its corresponding IP communication parameters,
wireless communication settings, and read the device number assigned to the Modero panel. Both
CV7 panels can use the NXA-WC80211B/CF wireless card for wireless communication. This card
also supports Wired Encryption Protocol (WEP) encryption of 64-bit and 128-bit key lengths. Refer
to both the Secondary Connection Page - Wireless Access Overview section on page 55 and
Configuring a Wireless Network Access section on page 57 for more detailed information of setting
up the Modero panel for wireless network access.
7" Modero Widescreen Touch Panels
Press and hold the grey Front Setup Access button (below the Modero LCD) for
6 seconds to access the Calibration page.
Press the crosshairs to calibrate the panel and return to the last active firmware
page.
Firmware Pages and Descriptions
The request to touch the crosshairs
is the first on-screen message
Calibration successful is the second
on-screen message that appears
after the calibration process is
completed
On-screen crosshairs used for
calibration of the touch device
105