Configuring Communication; Modero Setup And System Connection - AMX NXD-CV7 Instruction Manual

Configuring Communication

Communication between the Modero panel and the Master is done using either USB or
ETHERNET (DHCP or Static IP). Ethernet communication can be achieved through either a
direct connection (Ethernet) or through the use of the optional NXA-WC802.11B/CF wireless
interface card.
Before commencing, verify you are using the latest NetLinx Master firmware.
Verify the NetLinx Studio program being used is Version 2.3 or higher.
USB input devices must be plugged into the rear or side USB connectors before the
G4 panel is powered-up. The panel will not detect a USB connection of this type until
after the unit cycles power.

Modero Setup and System Connection

1. Press the grey Front Setup Access button for 3 seconds to open the Setup page (FIG. 47).
FIG. 47 Setup page
2. Press the Protected Setup button (located on the lower-left of the panel page) to open the
Protected Setup page and display an on-screen keypad.
3. Enter 1988 into the Keypad's password field and press Done when finished.
Clearing Password #5, from the initial Password Setup page, removes the need for
you to enter the default password before accessing the Protected Setup page.
4. Press the red Device Number field to open the Device Number keypad (FIG. 48).
5. Enter a Device Number for the panel into the Device Number Keypad.
The default is 10001 and the range is from 1 - 32000.
When using multiple panels within a NetLinx System, remember to assign unique
Device Number values to each panel so that all assigned panels appear in the
System listing for the target Master.
6. Press Done to close the keypad, assign the number, and return to the Protected Setup page.
7" Modero Widescreen Touch Panels
Configuring Communication
Connection Status
Red Connection Status icon -
indicates no connection
to a Master
Green Connection Status icon -
indicates communication
to a Master
Battery Base button doesn't appear
until NXT is connected to a BASE/1
47