Connecting And Using Usb Input Devices - AMX NXD-CV7 Instruction Manual

FIG. 42 RJ-45 wiring diagram

Connecting and Using USB Input Devices

The CV7 panel can have up to two USB-capable input devices connected for use on its different
firmware and TPD4 panel pages. These input devices can consist of a keyboard or mouse.
USB-connected input devices are not detected and recognized by the panel until
power is cycled to the unit.
A mini-USB connection is only detected after it is installed onto an active
panel. Connection to a previously powered panel, allows the PC to detect the
panel and assign an appropriate USB driver.
1. Insert the input device USB connectors into the appropriate USB connector on the panel.
2. Press the on-screen Reboot button from the Protected Setup page to save any changes and
restart the panel.
3. After the panel splash-screen disappears:
7" Modero Widescreen Touch Panels
If a USB mouse has been connected, a mouse cursor appears on the panel screen and its
location corresponds to the mouse cursor position sent by the external USB mouse.
If a USB keyboard has been connected, only on-screen keyboards and keypads will
reflect any external keystrokes sent from the external USB keyboard.
Installation
43