Yamaha YZF-R6T Supplementary Service Manual page 480

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
CHECKING THE BULBS AND BULB SOCKETS
email: info@motomatrix.co.uk
CHECKING THE CONDITION OF THE
BULBS
The following procedure applies to all of the
bulbs.
1. Remove:
S bulb
WARNING
Since the headlight bulb gets extremely hot,
keep flammable products and your hands
away from the bulb until it has cooled down.
CAUTION:
S Be sure to hold the socket firmly when re-
moving the bulb. Never pull the lead, other-
wise it may be pulled out of the terminal in
the coupler.
S Avoid touching the glass part of the head-
light bulb to keep it free from oil, otherwise
the transparency of the glass, the life of the
bulb, and the luminous flux will be adverse-
ly affected. If the headlight bulb gets soiled,
thoroughly clean it with a cloth moistened
with alcohol or lacquer thinner.
2. Check:
S bulb (for continuity)
(with the pocket tester)
No continuity ! Replace.
Pocket tester
90890-03112, YU-3112
NOTE:
Before checking for continuity, set the pocket
tester to "0" and to the "Ω
a. Connect the positive tester probe to terminal
1 and the negative tester probe to terminal
2 , and check the continuity.
b. Connect the positive tester probe to terminal
1 and the negative tester probe to terminal
3 , and check the continuity.
c. If either of the readings indicate no continuity,
replace the bulb.
8-6
ELEC
1" range.