Yamaha YZF-R6T Supplementary Service Manual page 16

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
Route the radiator fan motor lead (right) by the out-
side of the clutch cable.
Route the radiator fan motor lead (right) and clutch
cable by the inner side of the coolant reservoir
tank hose and radiator return hoses (2 hoses).
The punch mark starting point should be lower
than the clamp's top end.
However, the aiming position of the punch mark
starting point should be 5 mm (0.20 in) below the
clamp's bottom end.
Pass the clutch cable inside of the radiator hose.
Assemble as " " shown below when clamping.
Pass the pickup coil lead over the throttle stop
cable.
Tip of the plastic locking tie shall be pointed to the
inner side at the rear part of the vehicle.
email: info@motomatrix.co.uk
CABLE ROUTING
Clamp the clutch cable so that it is positioned in
this range.
Put and apply the hose clamp to it.
Clamp the clutch cable by routing the upper end of
the clamp along with the bottom end of the hose
clamp assembly.
9
SPEC