Dust Port - Delta 36-655 Instruction Manual

Tool Holders and Rail End Caps
Figure 39
Install front and rear end caps (A) on both ends of fence
rails using self tapping screws (4). Install fence holders (B)
using self tapping pan head screws (4). Install wrench
hook (C) using self tapping pan head screws (2). Install
miter gage holder (D) using self tapping pan head screws
(4).

Dust Port

DISCONNECT TOOL FROM POWER
SOURCE.
Figure 40
Attach dust port (A) to saw cabinet using pan head screws
(4) and hex nuts (4).
Fence and Micro-Adjusting Knob
DISCONNECT TOOL FROM POWER
SOURCE.
Figure 41
Turn fence body (A) on its side. Attach micro-adjusting
knob (B) to fence using button head screws (2).
Figure 42
With the fence locking handle (A) in the raised position,
lower the rip fence (B) onto the fence rail (C). Lock the rip
fence by pushing down handle (A).
16
Fig. 39
Fig. 40
Fig. 41
Fig. 42