Installing Blade; Table Insert - Delta 36-655 Instruction Manual

Installing Blade

DISCONNECT TOOL FROM POWER
SOURCE.
Figure 27
With the blade guard (A) in the raised position, assemble
the saw blade (B) on the saw arbor using the two blade
wrenches.
Figure 28
This view shows proper mounting of blade with teeth
facing front of machine.
NOTE: When installing blade, thread arbor nut
counterclockwise onto saw arbor.
Aligning Blade with Splitter
DISCONNECT TOOL FROM POWER
SOURCE.
Figure 29
Using a straight edge (A), check to see if the saw blade is
aligned with the rear of splitter (B). If alignment is
necessary, loosen screws (C), align splitter (B) with the
saw blade, and tighten screws (C).

Table Insert

DISCONNECT TOOL FROM POWER
SOURCE.
Figure 30
Lower saw blade and install table insert (A).
The table insert should be level with the table
surface. (If an adjustment is necessary, see
the section "Adjusting Table Insert".) Lock table insert in
place using button head screw (B).
NOTE: When installing, the table insert will automatically release
and lower the table guard (C).
14
Fig. 27
Fig. 28
Fig. 29
Fig. 30