Table of Contents
Advertisement
SAW BLADE
DISCONNECT MACHINE FROM POWER
SOURCE.
1. Remove the two table insert screws and remove the
table insert (A) Fig. 11. IMPORTANT: Be careful not to
lose two rubber washers (L) located under table insert
(A).
2. Raise the saw blade arbor (B) Fig. 11, to its
maximum height by turning the blade raising handwheel
counterclockwise, remove the arbor nut (E) (turn
clockwise), and outer flange (D) from the saw arbor.
3. Assemble the saw blade (C) to the saw arbor. Make
sure the teeth of the blade point down at the front of the
table, as shown in Fig. 12. Place the flange (D) and arbor
nut (E) (turn counterclockwise) on the saw arbor and
tighten arbor nut (E) as far as possible by hand. Make
sure that the saw blade is against the inner blade flange.
4. Place the wrench (F) Fig. 11, on the flats on the saw
arbor to keep the arbor from turning and tighten arbor
nut (E) (turn counterclockwise) using wrench (G) Fig. 12.
5. Replace table insert (A) Fig. 13, making certain
rubber washers are in place.
6. Place a straight edge or square (H) Fig. 13, on the
saw table extending over the table insert (A) as shown,
and check to see that inset is flush or just below surface
of table. If an adjustment is necessary, tighten or loosen
the two adjustment screws (K).
L
F
F
C
D
K
11
E
D
B
L
Fig. 11
G
E
Fig. 12
H
A
Fig. 13
A
K
Advertisement
Table of Contents
